- Details
- in Images
- The Blower's electrical panel
|
- Details
- in Images
- The solid state motor controller provides a controlled ramp up and down of motor...
|
- Details
- in Images
- The blower back in place and its wind line installed, Adrian fits wiring conduit...
|
- Details
- With the fan blades and stators back in place, the intake housing is reinstalled
|
- Details
- in Images
- Richard Flickinger countersinks some holes in the cover Bill Carr fashioned to c...
|
- Details
- in Images
- Now that the blower has been squeezed through the door, it's time for reassembly...
|
- Details
- in Images
- Blower and motor are now back in the Blower Room. Adrian Phillips and Pete Knobl...
|
- Details
- in Images
- Adrian inspects a part used to mount one of the fan blades.
|
- Details
- in Images
- Fan blade is aligned to previously recorded marked position and securely tighten...
|
- Details
- in Images
- Pete fishes some wire through the electrical panel
|
- Details
- in Images
- The motor controller is fastened to the wall
|
- Details
- in Images
- The motor is set aside while the blower is further disassembled.
|
- Details
- in Images
- The heavy motor 20 HP blower motor is slid onto the lift
|
- Details
- in Images
- A lift is put in place to support the weight of the motor
|
- Details
- in Images
- Adrian begins the removal of the 20 HP blower motor
|
- Details
- in Images
- Adrian Phillips removes the clips holding one of the fan stators as Bill Carr st...
|